Questions & Answers for: Harley Davidson FLSTF Fat boy frame diagrams

Question about 1993 FLSTF Fat boy

1 Answer

blinker going out The blinker works great until I insert the shaft into the frame, but every time it touches the metal around it the light goes out, no spark or anything, I have checked the wiring ...

Ad

Question about 2000 FLSTF Fat boy

0 Answer

wiring diagram for rear fender can you show a wiring diagram for rear fender Hi Harleycrash, for a free wiring diagram please visit the website below and good luck. Harley Davidson Wiring Diagrams and

Ad

Question about 2000 FLSTF Fat boy

1 Answer

...or tube running downwards and slightly to the rear of the bike. Follow this tube down along the frame behind the transmission on down to the bottom tube of the frame behind the exhaust pipes. ...

Question about 2003 FLSTF Fat boy

1 Answer

Can't find oil plug for 2003 fat boy Look down at the bottom of the frame behind the exhaust pipes. There is a large hose that runs down that way with a plug in it. Harley moved the drain plug to a ...

Question about 2003 FLSTF Fat boy

1 Answer

...mechanism, that chrome cover on the right end if the transmission. The hose goes right down by the frame and behind the exhaust system. It either has a metal plug in the end of the hose or the hose ...

Question about 2003 FLSTF Fat boy

1 Answer

...the backside of the tank and goes down behind the transmission. It comes back out down low on the frame just in front of the swingarm and behind the exhaust pipes. It either ends here with a plug

...will not turn over just clicks even when jumping Check battery ground and ground to motorcycle frame. It is a good idea to remove ground wire and "scuff" lightly to attachment point both at ...

Question about 2000 FLSTF Fat boy

0 Answer

...frame. Battery should have a charge of 12.5 volts or better. If it turns over check for spark at the plugs, if not check circuit breakers and ignition switch, starter relay, and relay wire to starter ...

Question about 1993 FLSTF Fat boy

1 Answer

...Harley parts department or maybe this will help: For removal block the motorcycle underneath the frame so both wheels are raised off the ground and then remove the cotter pin and washer from the ...

...is getting hot what do I do Hi, Shontte check your battery ground cable where it attaches to the frame make sure there is no corrosion and it has a clean tight connection are you blowing any fuses ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...