Questions & Answers for: how can found a diode

...found that D854 (dual diode ) was shorted . replaced it with another kind of dual diode . it was ok and the monitors goes on . but i wanted to try again if without soldering the dual diode the led ...

...diode. Found blown 10a fuse blown on display pcb.Replaced fuse but found blown diode on mircowave power supply.Dose this mean the microwave unit is blown or is it worth replacing the diode and where ...

...anyone tell me the value of this zener diode? It should be at the back cover, just where the model number is. If you have the TV open, it may also be found inside, maybe on or around the tuner

found that the Diode D2250 was bad so replaced it as well and now the set works fine. Maybe this is what is wrong with your's and others as well. It made sense for me to check the diode as it is right

...price of a new adapter. Thanks, Bea have that adapter tested, found defective diode sb260 near dc output, however after replacing different specs of diode it powered up then diode was busted

...diode on a lap top its on the charging side,i have found which one it is i was woundering if i could solder a low amp fuse wire across to mend the problem? No. A diode holds a charge in one direction ...

...found DIODE SHG2D SHS (HS) we need to replace it but I do not found it in datasheet. Can you help me to found a similar diode Many thinks Hi All, The SGH2D diode is rated at 200 volts 2 amps so so a ...

which has 3 leads double diode in a single diode . if found out , OK by multimeter even though ,replace that diode . if persists then check the mosfet 'irf 630' or check the base resistance connected

...diode also found one failed test on ignition switch but in acc mode did't think would effect run & start modes DO NOT JUMP OR ADD FUSE the purpose of a is to change power levels like volts to ...

...found an open resistor and a shorted diode Look for another diode on that circuit board that looks identical and take a reading in ohms with no meter and that the diode you will need to replace the ...