Questions & Answers for: kawasaki fork seal

Question about 2005 EN 500 Vulcan

1 Answer

...fork tube ,, wot i do to seat the seal in to the bottom part of the leg is use a piece of drainage plastic pipe the same diameter,,,ie, like u see on sinks and washin machines,, the white pipe, use ...

Ad

...fork seal leaking. is this a contribution to my problem.? Yes the leak is causing uneven pressure on the front of the bike! The pressure in the left fork is greater then the right fork and will cause ...

Ad

...seal in with a rubber mallet that way you cant damage the fork. hi mate take the forks off just use a screw driver to get the dust seal off and inside there will be a clip take the clipp of and yank ...

Question about 2001 KDX 125

1 Answer

...fork oil seal replacement do i need to remove the bottom hex nut on a 1990 kz 125 to get at the fork oil seals? General intructions for most bikes: Remove front wheel. Loosen fork tube clamps at top ...

...fork seal leaks Suspension, and Chain guide is missing so you get a clunking sound under low rpm acceleration because the chain hits the swingarm. chain needs adjusting or new chain needed, shouldnt ...

I need to replace fork seals on my 2000 Kawasaki KX250 I am a little concerned with purchasing standard fork seals from dealer as I purchased the bike used and the forks do have stickers on them for ...

...piece of PVC pipe cut in half then secured around the lower tube to drive the seal. Try a search on replacing fork seals for more info. 5w oil is standard but i have heard that 7 works well Good

I have a 2003 kx 85 , It has pro tech suspension , front fork seals are leaking , would stock fork seals fit this protech suspension? How hard would this be to do myself? Ive done lots of other work ...

Question about 2002 VN 1500 Vulcan Meanstreak

1 Answer

...seal and pull the fork apart sliding the fork leg up the stancion and sharply pulling down on it to pull the seal out, repeat this till theseal comes out, (tip) undo the fork top nut while the forks ...

...FORK SEALS BEGUN LEAKING WAS ADVISED TO SLACKEN WHEEL PINCH BOLTS ON FORKS PUMP THE FORKS FEW TIMES?is this true? @ NO. IF they are leaking, either they have been overfilled, you nicked the seal ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...