Questions & Answers for: Harley Davidson FXDBI Street Bob fork leak

Fork oil What is the correct quantity of oil for the fork tube and what is the level measurement from the top of the tube? hi ya poor the oil in with the forks compresed right down . poor oil in until

Forks rebuilt, oil leaks. need the correct assembly sequence for 49mm front forks on a 06 Dyna Street Bob(FXDBI). Followed procedures in shop manual, think it is wrong. Forks leaked. Think the washer ...

...fork seal leaking after 10,000 miles. The seal bushing had poor craftsmanship and scratched the tube casuing seel to leak. is this common? Not very common, but I don't see how the seal could scratch ...

inside slider tube on 2007 49 mm showa front forks there is a teflon looking bushing or stop, I can not see how to remove it, want to do a performance coating on slider an it will be subjected to 350 ...

where is the drain plug to drain the fork oil on my 2006 streetbob There is no drain screws on forks. You have to take the fork tubes off to drain them then turn them upside down to drain oil out ...

What's your problem?how much fork oil do i put in a 2009 fatbob? What's your problem?how much fork oil do i put in a 2009 fatbob? Hi Courtenay, for more information on your question please

how much fork oil is used in each fork tube for a 2007 dyna streetbob how much fork oil is used in each fork Hi Anonymous, for more information on your question please visit the websites below and ...

how to fix leaking front forks on street bob Hi Anonymous, for more information on your question please visit the websites below and good luck: Delboy Garage How To replace regular type fork seals

change fork oil street bob 2007 To change the oil or to rebuild a 2007 DYNA front fork FIRST raise and support the motorcycle so that the front end is off the floor and the forks are fully extended, ...

2009 harley street bob fork seal replacement how to I have never seen seals replaced without dismantling the forks. The seal will come in a fork revbuild kit whether the bushings etc are used or not. ...