cv joint question Can stationary lock to lock steering stretch or damage a cv joint or drive shaft. One person told me it could. Cause I tend to do this an awful lot when getting out of parellel ...
...of extras. 1. Check brakes 2. Inspect axle shaft seals,Constant Velocity Joint Boot, Transmission 3. Lubricate Chassis,linkage,steering, suspension 4. Replace Engine oil & filter 5. Rotate ...
Can a damaged CV joint damage the transmission? Not usually. You don't want to drive it with a bad cv joint,if it breaks, you may get hurt, if you have an accident.
ford fusion front end noise when doing tight three point turn or manovers popping noise when turning is usually caused by worn CV joints. Inspect CV boots for tears. Torn boot will allow dust to get ...
HOW LONG DOSE IT TAKE TO FIX AN CV JOINT? if you have all the tools; balljoint remover and all necessary tools to take tire ,idle arm. about 2 hrs by yourself at most.
...and I think I'm hearing a slight grinding noise when I make a left turn. Could this be the CV joint? More than likely that this could be a worn CV joint needing replacement if it is a front wheel ...
...ford fusion awd v-6 driveline or suspension area or assembly makes a noise (possibly a bearing) when car is in motion. When not moving and motor is running, there is no noise. Appears to be coming ...
loud poping noise when turning Could be a few things. End link bushings, struts, cv axles, tie rods, or ball joints. A suspension component for sure.
Question about 2006 Fusion
...ford fusion SEL with the 3 litre v6 and six speed automatic transmission. Its at 161000 miles currently. There is a loud rumbling nois coming from the front end. I had the tires, bearings and brakes ...
how to replace passenger side cv joint remove the axle from the car and use the services of a cv joint reconditioner shop
Usually answered in minutes!
750 Questions
244 Questions
135 Questions
91 Questions
53 Questions