...cv axle out of the spindle to replace lower ball joint? It has auto hubs. take the net off the end off the axle shaft and seperate the spindle from the ball joind and the tierod end. now just push or ...
...barings, shocks ,bolts, rotors, brake pads, please could you help me out what could it be Try replacing the CV joint that lies just behind each front wheel in line with the axle end. Hope this
axle shafts so they can be replaced fairly simple. the hard part is getting all the stuff out of the way to get to it. You can Get detailed instructions from alot of places depending on your vehichle.
...Ford Expedition. ITS A HARD ONE COULD BE A UJOINT / CV JOINT. COULD BE STUCK IN 4X4 I WOULD HAVE TO EXPERIENCE IT TO TELL YOU !! I would say the most likely are--- the drive axle joints are bad. You ...
...help lubricate the joint at all. Any hole in the boot would cause grease to come out of it while spinning. If the cv joint is making noise the ONLY way to repair it is to rebuild or replace the
...cv boot contains grease to lubricate the joints and if the boot is cracked it very well may mean that the joint is dry due to moisture and dirt penetrating the boot. On the other hand, are the tires ...
noise in the front end 03 eddie bauer expidition when i turn and excellerate,i can hear a weird noise then i hear a knock in the front wheels sounds like cv joint in axle or hub bearing going out
Question about 1999 Expedition
...joint both, cv axles both. And my expedition still clunks and jerks when I turn corners. Why? I've replaced upper ball joint both, cv axles both. And my expedition still clunks and jerks when ...
Usually answered in minutes!
2,187 Questions
1,825 Questions
1,627 Questions
1,696 Questions
1,161 Questions