chain saw kicking back on startup how can i get around to get this fix? Could be a sheared flywheel key. Pull the flywheel and check it.
Question about MS211 - 14"
...flywheel - remove it and check the woodruf key (the snall ridge inside the tapered hole where the crankshaft goes through is still there. That small ridge should go into the groove on the crankshaft ...
Question about Br500 Br550 Br600 Flywheel 42824001200
my flywheel is aligned there is a key way built into the flywheel... it keys into the crank... no other way... but aligned with what ??? if you do not physically see a key way then did it shear off ??
...key on the flywheel and not changeable. If there is a problem check the flywheel still has the key moulded in place in the tapered hole that goes onto the crankshaft . If it is missing you can get a ...
Question about Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835
...key molded into the flywheel itself, so if that becomes damaged, you will need to replace the entire flywheel, I would also at that point reccomend a new flywheel nut and engine seal on that side as ...
Question about Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835
flywheel key will cause timing issues but not eliminate spark. Either you have purchased faulty parts or spark is not your problem. Remove the ground wire from the coil, be sure you have tightened the
Question about Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835
...a Stihl bg55 leaf blower, I slide flywheel onto crankshaft center to the key, it has movement will it have some movement on the wheel before you tighten the nut.. it may. just make sure it's
...to the huskies.Your not suppose to leave gas in it over the winter, check the key in the flywheel,any wear in the key can cause it to be out out of time and it will cause no spark at the spark
Question about Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835
...flywheel key. The key is part of the flywheel. Check to see if there are 'rub or scrape' marks on the outside of the flywheel. Adjust coil clearance to .010". Coils on those models are normally very ...
Question about Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835
...flywheel ok key way in place ground wires ok! Set the gap between coil and flywheel to 0.010 inches, if possible disconnect the stop wire from coil to eliminate that part of the circuit. If spark, ...
Usually answered in minutes!
61 Questions
59 Questions
27 Questions
22 Questions
19 Questions