Question about CP-220 Thermal Photo Printer
flat spot inside the white plastic hub. Hope this helps. This is a heater breakdown These may help http://www.fixya.com/support/p360580-canon_cp_220_thermal_photo_printer/solutions or go to Canon Tech
...from the buttons to the circuit board. Carefully moved the flat cable a bit and now its a ok. Prolly just oxidation. You'll need a small screwdriver set, four tiny screws keeping A495 case
Question about PowerShot A710 IS Digital Camera
...four blades of the lens cover came out. In the process of reinserting the blades and their springs, I then lost a 1 cm. long spring (one looped end, one flat end). Assuming I can find the spring, ...
Question about ZR800 Mini DV Digital Camcorder
...four-pin firewire cable (small and flat) as opposed to a 4-pin s-video cable (round). If you are talking about the latter, there is no control signal in an s-video cable so there is no "recognition" ...
...four times then soon click “Power” button, to confirm the selected action (reset counter absorber).Turn off the printer and turn on againPlease come back and just gave a vote, it will gave me some ...
...four corners and edges of the envelopes to remove curls and bends, as well as any air contained. Note: The flap of the envelope should be straightened if bent. If the envelope is curled, hold the ...
...Flat and then by the tip of Your thumb Press it in inner side To demonstrate it the image is given below: Further assistance i am here to help Please don't forget to click on Four thumbs which are ...
...flat plate). Check to see if it is stuck down. If so the camera thinks there is an external flash installed and will not operate the built in flash. You can gently pry up the spring and then remove ...
Question about PIXMA MG3250 All-in-One Inkjet Printer 9.2 ipm, 4800x1200 DPI, Colour, Wi-Fi, PC/Mac
...four corners and edges of the envelopes to flatten them. If the envelopes are curled, hold the opposite corners and gently twist them in the opposite direction. If the corner of the envelope flap is ...
Question about Powershot A2000 IS Digital Camera
...going flat after four or five exposures. Two Cameras with consecutive serial numbers giving the problem. If you are using NiMH batteries it could be that they've come to the end of their useful
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions