Questions & Answers for: flams

Maytag Dryer Tstat wiring Have Maytag Part# 306911 need correct wiring diagram(what color wire to which prong?) I believe that this part is a thermostat. If im not mistaken, it shouldnt matter which ...

my dryer is gas it wiil only start the flam when you frist start it affter that the piolt stats but dose not light Your gas valve coils need changing. Once they heat up they are shutting down.

have-kenmor-80-series-dryer-about-5-yrs-old-losess... have-kenmor-80-series-dryer-about-5-yrs-old-losess-flam-about-6-min-into-cycle attemps to relight no flam. replace coil kit no 279834.coils will ...

gas dryer flam will burn for about twenty minites gas dryer flam will burn for about twenty minites then go out have replaced thermal fuse door switch and roll out flame switch on burner model # is ...

Dometic refrigerator will not stay lit Refrigerator works on electric but does not stay lit on propane gas. It lights but goes out in a couple of seconds. sand your thermal cupler off or replace it ...

my 30000 btu pro com blue flam has about 35% orange flams You probably have a plugged orifice. The gas is injected into the burner via a small orifice and, when this plugs, the air / fuel mix is ...

I have 2Psi inlet pressure so if I don't use regulator pilot is working but huge flam. But when I put regulator in (3 Line pressure coming is 2PSI and I have regulators attached to all my natural ...

My maytagdryer pyd4500aww flam does not sustain...I checke all safty showing countinuty...I replace coils and clean the vent also....but same problem first time flam goes to 30 sec and after just 10 ...

My Maytag dryer mod#pyg4500aww First time flam stays until 50 sec and after that not more then 10 sec.....and flam is not so strong as it strong in normally....I changed coils and clean the duct.... ...

I have a ruud silhouette gas furnace and I have change everything out and it still won't stay on. I have change out the brain board the flam igniter the roll out and the high limit and when I ...