flame rod in the burner it may be abd. This a small rod that sticks into the flame. When it is lit the flame sends a signal thru the rod that the flame is on. Try to sand paper and clean the flame rod
...flame rod issue or the flame is not getting to it in time. The flame rod is located either far right or far left in the burner box and has only one wire going to it. It should be in line with the ...
Question about AquaStar Indoor Natural Gas Tankless Water Heater with Vent Hood #125
...flame rod, or did it jump up over it leaving the rod in clear gas below the flames?In the LCD display, upper right corner, is an indicator in the shape of a flame. It is visably displayed when the ...
Question about AquaStar Indoor Natural Gas Tankless Water Heater with Vent Hood #125
...a schematic of the control board? Hello Flame rod should have done the trick.Make sure the rod & the control are GROUNDED (earth).Make sure the rod is not touching anything & in the gas
...flame sensor rod and the ground rod (middle rod). This DC amperage is produced by the current flowing through the flame between those two rods, and up the white wire to the circuit board. The flame ...
flame rod is sensing a flame when there shouldn't be one. This is caused by a grounded flame rod or pinched wire. For some reason the flame rod could be touching metal inside the heater. The flame
need to clean flame rods Open it the flame compartment, disassemble and remove, clean the rods with crocus cloth then set them back. Be careful to set the proper distance between the flame rods.
Question about VG40 Gas V Series Braising Pan - 40 Gallons
...flame rod short"? the item will not turn on. This probably means that the flame sensor is shorted to Ground. This sensor is usually a flame rod that is partway into the flame and detects a current ...
Question about 56000 Btu Gas Furnace
...Flame rod senses flame Burner continues to burn until thermostat stops calling for heat By your description, I would polish your flame rod, it will be a metal rod that is insulated from the bracket ...
Question about 56000 Btu Gas Furnace
...flame rod), its the rod that is opposite of the ignitor. Now that we have confirmed that, try cleaning the rod with some fine sand paper, nothing too gritty. the goal here is to try to clean any ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions