Question about RT404 Car Audio Amplifier
...amplifier. Audio amplifiers are not special and can be fixed. In many cases, the output stage is a power MOSFET or a power audio amp IC. The only issue is the availability of the parts in your
mtx81000d 3rd chance I'm looking for parts for my speaker blower one last time. It was hooked up with all the right wiring and a relay , 0/1 wire, optima 31 series battery, and the amp had been ...
mta 1501d my mtx1501d put out dc at the speakers i replace the caps and transistors but still has the same problem. I opened the amp and tested the resistors at 245,246,247,249 and get a straight beep
...like your amp is bad and the output is stuck against one rail. I have repaired a TC6001 before and I know that the rails are +50v and -50v. You will have to replace your subs and get the amp
...output. The humming is at approx. 30 volts AC - the power supply voltage. The amplifer has broken down and what you are hearing is the oscillation of the voltage supplied to the chip. I've fixed mine ...
Question about JackHammer JH600 Car Audio Amplifier
I have an MTX Jackhammer 600. I just took out my subs, replaced them with new subs with the same parameters in the same box and they have low volume and distortion. The only wires unhooked were the ...
Amp burned out I unplugged my subs and left the wires dangling in the trunk while on a road trip. The +/_ wires touched and melted together. This blew the fuses on my amp. I thought I could simplt ...
Question about Thunder 6500D Car Audio Amplifier
when i hook the postive/negitive and remote wire my amp whines everthing is hooked up correctly but i get no output there are coils inside the amp the power it an ur output input could be burned out .
...Why? My mtx amp has 60 volts at the outputs. What should I look for? any dc voltage at amp output is a sign this is blown. the problem is on the output transistors and can only be fixed by a ...
Usually answered in minutes!
55 Questions
42 Questions
24 Questions
26 Questions