...no Purge Flow Blocked Fuel Vapor Hose or Canister Purge Valve Stuck Closed PO- 1506 Idle Air Control Overspeed Error (IAC) Air inlet plugged or Bad IAC Valve PO-1744 ?? don't have,looks Trans ...
stuck closed. where are these sensors and whats the fix? The purge sensor is located behind the passenger headlight assembly. Remove the headlight, locate the purge sensor and follow and inspect
...stuck open after the first harvest, Do you think the valve needs to be replaced or just a bad contact? Pretty sure it is a bad valve. You can unplug the unit and disconnect the wires to the purge ...
...fix this or even if it is worth fixing and a est about how much it would cost thank you CODE P1443 - LOW PURGE FLOW OR NO PURGE FLOW CONDITION DETECTED.POSSIBLE CAUSES EVAP CANISTER PURGE VALVE STUCK ...
Question about 1996 Thunderbird LX
...fix? I just have to said diagnostic module tank leakage pump too high Fault codes do not have a single reason for being set, there are multiple reasons. here is the info you need to know about this ...
fix fault code po443? P0443 INFINITI - EVAP Canister Purge Volume Control Solenoid ValvePossible causes- EVAP control system pressure sensor - Damage harness or connectors to the Purge Control Valve -
...stuck closed (mechanically). Check for blockages between the fuel tank, EVAP canister purge valve and engine intake manifold. Check obstructions in the EVAP canister purge valve diaphragm and ports. ...
fix this Ok on the top left side of your engine between the throttle body and the brake master is the purge valve the sensor is black with a red connector . The p1441 set when that valve is stuck open
Question about 1997 Thunderbird LX
fix the code error p0443 in a 2006 BF Falcon Futura... its using a lot more gas than it should be... P0443 (Ford) EVAP Canister Purge Valve Circuit Malfunction The control signal to the purge valve is
Question about 1997 Thunderbird LX
...fix.but not RPM off. then purge solenoid. RPM high is the best clue here. for sure mine fails every 50k miles it seems and pull the valve and flex the valve inside while spraying silicon oil spray ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions