...door hinge have a new door hinge and got the door off but how do you remove replace the hinge - do you have to separate the door and if so any tips on how to do it without breaking the lugs? yes u do ...
Question about Aquarius WD63 Front Load Washer/Dryer
...fit a new door hinge and two new parts of the inge bearinng kit (bits with holes for hinge pins). Can't get these old hinge bearing lugs out and think I need to split door but can't see to how to do ...
...and the oven light stays on. cooking times are increased Would suggest you need new door hinges fitting. replacing hinges on this oven. Take a
...fit a new hinge to a Hotpoint WM64P washing machine Remove the wire clamp that secures the door seal to the front of the washer. Pull the seal of the front. and double it back inside the washer. Undo ...
fit a new door on a washing machine fit a new door on a hotpoint washing machine You need to remove the wire clamp that holds the door seal on to the front of the cabinet, then pull seal off. This ...
Question about RB787 Electric Kitchen Range
...fit an oven door to a Hotpoint BD81P oven? My hinges need replacing ? Go to WWW.YOUTUBE.CO.UK In the search box enter---FITTING OVEN DOOR HINGES You will find some very informative videos on how to ...
Question about RB787 Electric Kitchen Range
...close the door and make sure it is seated properly. with door closed tighten top hinge mount the open door if needed to tighten inside mount. May need to be done a couple of times to get correct ...
We have a Hotpoint double oven spec# BD52K and after having the element refitted have notice that the bottom oven door no longer fits flush causing the oven not to seal correctly. is there any way ...
...seal off of front panel, Pick up metal bracket. Now with the hinge attached to door hold in place and place bracket behind the two holes fit screws and then fit the seal and clip. ...
Question about Ultima WD72 Front Load Washer/Dryer
...door comes in two parts and the glass is sandwiched between the two parts. ( Take photo if in need ) you will see see a metal shaft and spring where your handle will fit. All the best and Happy ...
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions