...shop to have repaired? Replace the door hinge pins or adjust the door whichever will work. You can also adjust the door latch striker a little, but to much and door will not fit correctly in
...door like the lock cylinder yoou will need to remove the inner plastic panel to gain access to the clip that holds the cylinder. Replace in reverse order and adjust to fit properly before tightning ...
...another drivers door after mine was damaged during attemt to steal car can not get holding pins out of hinges to change doors help please interference fit ,bigger hammer and a decent snap on ...
...I have to lift it to open or close check the door hinge pins and make sure they are fully seated. Also check the hinge pin bushings - they are made of bronze and if they wear out, the door will ...
...is not fully closing to shut the switch if you push the door switch in it will go out try a rubber fitting over the top of the switch bar to give added length to it one of your door switches is
...door hinge pins also for snug fit all around. If it has a hole in the roof, then you are just going to have to buy some aquarium sealer and rub it around all the cracks and seals in the moon/sun roof ...
where is the fitting to lube 2002 ford escape The door hinges and hood hinges and rear deck lid. Also all door latches with white lithium grease.
door If the sheet metal is dented enough, no amount of adjusting will solve the problem. The amount of play you can get would require adjusting all 3 points of attachment - not just the hinges. If the
Question about 2008 Mondeo 2.2
...that need to be removed. Once the new door is on it must be aligned to make sure that the door fits
Question about 2002 Taurus
...in really tight. You may need a large phillips bit that fits a ratchet wrench, impact wrench even better. Make marks to insure the door goes back to the same spot. on the hinge mounts to the
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions