...door itself is droopy, adjustments are made by the hinge by loosening the bolts and lifting up or down. Multiple attempts will be necessary to get it just right. Dont get frustrated if it doesnt fit ...
...DOOR AND LOOK AT THE STRIKER TO LATCH POSITION. IT SHOULD BE AT THE CENTER OF THE LATCH. IF NOT ADJUST IT TO FIT BETTER. CLEAN THE CONTACTS WITH SCOTCH-BRITE THEN PUT A LITTLE DI-ELECTRIC GREASE ON ...
Question about 1994 Silverado 2500
...door in small movements and check the fit after each movement. Be sure that there is no binding or interference with adjacent panels. Repeat this procedure until the door is properly aligned. R/V ...
fit except possibly the rear doors. Measure the length of yours and then the Suburban to be sure they are the same length. Front doors should be the same. Be sure to watch for and count shims when you
...door pin and bushings for a 91 s10. no parts stores have them. any suggestions? i appreciate it. hi, find a suitable BOLT with ny-lock NUT. use a ROLL PIN (may need to drill-out to fit, needs to be ...
...door to close it then the catch will have a mark (or worn spot) on it below the top. To adjust it you will need a particular type of wrench to fit in. I cannot remember what General Motors uses, but ...
...door. You will need new bushings. If you find that the bushings are not fitting snug to the hinge, loose, you may need to drill the hole out a bit bigger, and use an over sized pin and bushing to ...
...removed. Or prop up the door with blocks at the bottom to hold door up. Get the new door bolted up. Adjust the door so when closed, the gap all around the door is even-so it looks like a seamless
Question about 2001 Chevrolet Blazer
...door hinge pins in upside down I have had to replace these pins multiple times the clip does not hold it for very long Are you replacing the bushings when you replace the pins? The fit should not be ...
...bolt. Top hinge, bottom bolt. Bottom hinge, bottom bolt. -Tighten until tight BUT do NOT overtighten. -Refit the door check strap. -Reconnect the wiring loom connector. -Close the door to check
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions