Questions & Answers for: how to fit a door hinge

Question about Dometic Refrigerators

1 Answer

...door the hinge pins fit into round metal guides. In turn, the metal guides are held in place on the door corners by decorative plastic strips which run the widt of the door at the top and bottom. On ...

Ad

...fit the wrong one and the door won't rise! Whichever hand you've got, try fitting the other hand and your problem should be solved. Good luck! If this has been helpful, please remember to rate my ...

Ad

Question about W120VW Front Load Washer

1 Answer

Fit a new door hinge anyone able to advise me on how to fit a new door hinge please? Remove the wire clamp securing rubber seal to front of washer, pull seal of front of washer, this will give you ...

Question about W120VW Front Load Washer

1 Answer

...fit saloon door hinges . how to set out the job before fitting saloon door hinges Set the bottom height first and make sure the two are level ... then fit the door ... allow for the up and down ...

Question about W120VW Front Load Washer

1 Answer

Door Fit the door to the oven with the metal receivers in the slots on the oven. Once the receivers are in the slot, fully open the door (in a downward position). Flip the U shaped pieces over to lock

Question about W120VW Front Load Washer

1 Answer

...fit an oven door to a Hotpoint BD81P oven? My hinges need replacing ? Go to WWW.YOUTUBE.CO.UK In the search box enter---FITTING OVEN DOOR HINGES You will find some very informative videos on how to ...

Question about W120VW Front Load Washer

1 Answer

side of door opening Remove the door by unscrewing the top hinge and lifting off. Remove bottom hinge. Using what was top hinge, fit to bottom of opposite side. Fit door on with "top" hinge and secure

...hinge. If you are lucky, they will reverse fit to the other side as they are. If not, use what was the top hinge as the new bottom hinge, fit the door and use the bottom hinge as the new top

...door. Besides hinge receivers should be replaced first, before the hinges, that in my experience rarely break I dont like the bent twisted story. I bet the little plastic U-roller in the hinge ...

Question about RF378LXKS Electric Kitchen Range

1 Answer

...bolt. Top hinge, bottom bolt. Bottom hinge, bottom bolt. -Tighten until tight BUT do NOT overtighten. -Refit the door check strap. -Reconnect the wiring loom connector. -Close the door to check

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Refrigerators Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...