Starting and once started won't run 2004 Kawasaki Vulcan 1500 classic. 13,600 Miles. Couple weeks ago I tried to start it and nothing. Turned key on and off moved start switch on and off a few times ...
Question about 2004 VN 1500 Vulcan Classic
problem with sound inside engine kawasaki vulcan 1500 when start hi guru, i have vulcan 1500 spec USA 1991. so the problem is sound coming in inside engine . when we start engine nothing noisy inside ...
Question about 1996 VN 1500 Vulcan Classic
...final drive ratios on a vulcan 1500 For the gears: Gear ratios:1st 2.500 (40/16) 2nd 1.590 (35/22) 3rd 1.192 (31/26) 4th 0.965 (28/29) 5th 0.781 (25/32) Final Reduction Ratio 2.619 (15/21 x 33/9) and ...
hard to start when cold i can push start it and it starts right up G'day mate sounds to me like the starter is drawing to much power to leave enuogh for the ignition system go for battery , have it ...
the crank case is a very large cap that looks like it take s a giant screw driver. Unscrew it and pour oil in. Yes trans is lubed by the motor oil. The final drive is like a rearend in a car. Gearlube
Question about 2004 VN 1500 Vulcan Classic
how do you remove the rear tire on a shaft drive kawasaki vulcan. need to put on a new tire. Go to this site guy is good at explaining things and has a whole array of photos.... ...
I just got my first bike and I'm finally getting accustomed to driving it. Unfortunately I have had several falls the two which caused damage to the bike dented the gas tank pretty bad along w ...
Question about 2001 VN 1500 Vulcan Classic
I have a '00 Nomad 1500 Fi. I had a starter switch burn up and blow the main fuse on the solenoid. I replaced the switch and fuse and away I went. 2 weeks later the ignition fuse blew, and blew, and ...
I have a 2001 kawasaki drifter 1500. the owners manual says I need to do maintainance to the drive shaft at 15000 miles. It says something about the drive shaft needs to be greased took apart and ...
back wheel will not go backwards Sounds like a drive shaft problem. Could be bent teeth that only mate properly when moving forward and jam up when moving backwards. Easiest thing would be to remove ...
Usually answered in minutes!
175 Questions
86 Questions
60 Questions
52 Questions
44 Questions