Questions & Answers for: Honda VT 750 C2 Shadow final drive

1998 honda shadow will not start The bike has been sitting for a few months. tried to start it. It would run for few seconds then stop. This was on full choke. After about 30 minutes of back and forth

convert motorcycle from Japanese to US specs I have a Japanese made 98 Honda Shadow ACE 750 and would like to take with me back to the States. Noone can give me a straight answer on what I need to ...

WHAT SIZE CHAIN SHOULD BE ON A VT 750 SHADOW hi, i have aquired a 1997 honda VT750 SHADOW USA EDITION. Can you tell me what the spec is for a drive chain for this bike, as it doesnt have one on it at ...

speedometer not workin i have checked fuses ok wires ok pin on wheel turning wheel in sensor turning any idea nothing electrical about the speedo on that bike...so if the speedo drive on the wheel is ...

...final drive:Chain Physical measures Dry weight:229.0 kg (504.9 pounds) Seat height:700 mm (27.6 inches) If adjustable, lowest setting. Overall length:2,455 mm (96.7 inches) Overall width:980 mm (38.6 ...

how to adjust chain Normally you need to loosen those axle bolt on either side of the bike. Let me clarify, you know where the drive chain ends, the bolt holding the chain gear is the axle bolt which ...

final drive. The wheel should slide right off the spline of the final drive and roll out the back under the fender. If the wheel wont slide past the final drive let the air out of the tire. Be sure to

runs without plugwires on shuts off when you put it in gear Your cycle runs when you pull off one spark plug wire per cylinder. There are two spark plugs per cylinder and you did not remove both . ...

99 shadow 750 ace w/4k bought on friday bike sat so i changed oil/filter with honda approved products flushed cooling system checked all fluids and rode about a total of 65 miles performed great all ...

...by turning the air-fuel mixture bolt all the way in then your pilot/low-speed jet is too big. Final adjustment should be made with a clean air filter mounted to the carburetor. For more ...