Question about 1978 GL 1000 (K3)
1978 Honda Goldwing GL 1000 is stalling and running in 3 cylinder Hello there, my Goldwing is running in 3 cylinders; I have changed the plugs, cables are OK, gas reaches the carbs OK, pilot screws ...
smells like gas when I drive That could be a slow leak that is hard to find. or fuel too rich. Try to clean and dry off fuel lines carbs and tank. check often as you ride for wet fuel in those ...
...rear corner of motor(by final drive shaft) Using a funnel pour in 4 quarts oil (3.9 is correct amount, 1/10th quart does not seem to bother anything). Put plug back in , start up, and check for
...in first gear (disassembly required). I think in your case the spring has broken causing the same final result. It is possible that you have a bent shift fork, or other damage, unfortunately ...
final drive. The wheel should slide right off the spline of the final drive and roll out the back under the fender. If the wheel wont slide past the final drive let the air out of the tire. Be sure to
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions