Questions & Answers for: Chevrolet filling

I can't fill the tank. The nozzle keeps clicking off. 2003 Chevy s-10 about 70,000 mile runs good does not have a vent pipe like the older trucks and things are to tightly packed in place i can't find

where is my fluid fill on a manual transmission where do i find my plug and fill my manual transmission there is no dip stick and i can see the drain plug..and there seems to be a bolt in the front ...

...fill through the radiator and add to bottle after you are finished. Run the heat on high while filling and wait for thermostat to open and level to drop before final fill. The drain plug is on ...

...do you remove the water pump on a 2006 monte carlo Drain the cooling system. Refer to Draining and Filling Cooling System (LS4 Static Fill) Draining and Filling Cooling System (LZE, LZ4, LZ9 Static ...

...Clean off the dip stick and take a reading with motor running and tranni in proper position. Keep filling and rechecking untill it reads full while running and tranni in proper position. Once ...

...fit into the dipstick tube hole, and then fill it that way. Make sure you turn the vehicle on while filling it, and put it through all the gears, with your foot on the brake. This will make sure your ...

how much oil does my 2001 silverado k3500 with 8.1 L gas engine hold? All TEMPS......5W-30 Engine, with filter..........6.5 quarts [1] Cooling System, AT Initial Fill..........20.8 quarts Cooling ...

just replaced radiator in 2003 blazer old radiator leaked all fluid out put new fluid in to get home do i need to flush and fill or just fill ok do i need to jack up above heater coil to fill and does

...low on coolent, let the engine cool down, and open the radiator cap and fill it full from there. Filling the tank, will not add ANY coolent to the radiator untill it warms up (expands) and cools ...

How can I change oil in transfer case? If you want to know how here it is. Transfer cases have 2 plugs. A drain plug on the lower back of the case. And it has a fill/check plug. Remove top plug first ...