...filler neck on the car has a vent tube in side of the neck it is stopped up you need to take it to your local dealer to have it repaired hope this helps workitover Check the vent tube, if you see a ...
...filler tube allows road dirt and sand to accumulate with moisture untill the vents and filler tube are junk. Tried to fill tank and gas pours out all over the ground. Start complaints to Mitsubishi ...
...that runs down the filler tube to let the air out of the tank as you fill it, these tubes get kinked, replace the tube, this is part of the filler neck assembly so the whole thing must be changed
filler neck assembly the vent tube that runs along the fill pipe is collasped, the fill and vent are one assmebly, this is the only thing that cuases this problem, been a Ford dealer tech for 25 years
...clamps on filler hose and vent hose make sure it's not leaking there.If fuel pump was changed before filler tube connection on tank maybe leeking when under vacumme from perge systme and setting
...new filler tube. u will have to lower gas tank and remove screws from filler neck around cap to change out , easier if tank is empty. Replace the connector hose from the filler neck to the gas
Question about 1993 Econoline
...filler tube. Vent was clean Transmission shifts fine but it blows fluid out of the filler tube. I changed the fluid/filter hoping something would give but nope, still blowing out. Vent was clean, not ...
...filler tube and over the car and wheel. Current talk: 1) filler tube vent plugged, 2) filler tube back flow flap not working, 3) nozzle is in filler tube too far - pull nozzle back 1 or more inches - ...
Question about 2004 Cavalier
...filler tube replacement also changed vent tube valve only thing haven't tried is charcoal canister run the fault codes as the problem is more than likely the purge valve or vent solenoid of the EVAP ...
Question about 2008 Pacifica
...vent on the filler tubes for bent or blocked areas. As fuel goes in air must go out. That's a safety feature that you cannot override. Your filler/ tank vent is clogged and is not letting the tank ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions