Questions & Answers for: faulty temp gage

...temp gage will shoot up and then shoot back down. It will shoot up to the red zone, stay there for a minute or so and then rocket back down to below normal. Even though the gage shoots into the red ...

1/2 way for awhile and the repeats.Took out old thermostat, coolant is at proper level. Faulty gauge or Faulty Temp Sensor. Replace the Sensor and if this doesn't resolve the problem replace the gauge

NOT SAY THE ACCURATE TEMPATURE The ambient air temp sensor is located in the front of the vehicle near the core support.Chances are the sensor is faulty sending the wrong temp to the digital temp Gage

...temp because of a faulty thermostat. It also could be that the engine is actually warm and the gauge is wrong. Use the search feature, we've gone over this one a few times. Also note that P1296 has ...

...faulty temp sensor that's why it doesn't work. There are two locations to look at, it can be on the lower part of the radiator or it can be on the engine block. You will need to remove the connector ...

...temp. sensor connector and connect it to the good known sensor. If gage stays where it was, then this is not the sensor. Next step is to have electrical diagram of this model and see how exactly your ...

...this should be around 90deg C if the the temp gauge on the dash is in the middle. if this is the case, the gauge sender int engine block might be faulty of the gauge in the dash might even be

...temp is 170 Pete, it is the tendency of an old oil pump to pump weaker as it warms up, pump screen or tube could also be plugging. Could be a faulty gage, maybe try a different gage to verify pump ...

...on my 1990 Plymouth Sundance to flucate loose connection on the temp sender unit, broken wire to temp sender unit low coolant level in the system/ air lock faulty sensor or radiator fan not cutting ...

...engine check for dead short in the temp wire to the sender unit or faulty sender unit do not confuse sender unit for the gauge as against sensor unit for the coolant control for the ECM and ...