Questions & Answers for: Whirlpool no fast spin

..."gives" more than half an inch, you have to loosen the motor bolts and push motor upwards, then tighten the bolts very well. Try spin only to check, before closing the behind. It shd spin very

...fast spin open your lid quick to see how fast its spinning.. check and make sure your drain line is cleared and the water flow out fast...and if its spinning too slow problem is in the gearbox

...spin fast enough My Kenmore washing machine doesn't spin fast enough to get the water out of the clothes. It does spin but when you watch it, its really slow and the clothes are still sopping wet. ...

...spin (fast spin). If I set it to "gentle spin, would it disengage the fast spin? Whirlpool didn't know the answer! My Whirlpool WFC 7500 was installed with very little room on both sides (contractor ...

i have an whrilpool estate washer and it works fine till it spins , when it spins fast it all most looks out of balance but there is nothing in it , and it also maks ticking noises as it spins then ...

pool washing machine doesnt spin dry If it wont spin at all, check the lid switch. If it will spin but not fast enough to spin the water out of the clothes, it sounds like the clutch could be slipping

...spin cycle I don't think it is spinning as fast as it should be. How can I fix this? Most common to cause slow spin is slow draining. Remove the lower panel (3 screws) and remove the pump filter. It ...

...spin fast like it should do, the pump keeps pumping water out and the programme carries on, the clothes do spin round but really slowly and the pump still is going and the programme then ends and the ...

...fast spin and therefore don't finish wash. does it pump out all the water when it spins the first time? when they spin slow sometimes the pump is not pumping out all the water causing it to spin

...when spinning fast?? Not an uneven load, but that is what it sounds like. Washer 7 years old what could this be??? when on low spin not making the noise, only fast spin Load balancer stuck or