Questions & Answers for: fan running

...running the fan may not always run, There is a quick test for the fan circuit, disconnect the fan sensor at the thermostat housing, the fan should come on, this is failure mode, so if the switch goes ...

...fan not running where is the relay switch for the cooliant fan The tempature switch for the fan will be located on the radiator tank, most likly near the bottom or mid way up. It will have two wires ...

...fan not running. shut off engine. > Removed fan - ran fine when jumped to direct 12v pwr. > Continuity checked thermal fuze. Burnt out - replaced fuze... still w/n work after driving car for several ...

...fan is not running. I looked in the My condensor fan is not running. I looked in the back and it's dead. It spins freely if I spin it myself then it stops. I traced the problem of my door getting ...

...fan is running to fast and one fan is not running at all, engine cooling fan that is. Just wondering if someone might know whats up. It seems like one fan is getting the power for both fans. Also my ...

...fan from running(if the capacitor is defective) so look for this first. my 70 pint Danby was found dead and pieces of the fan all over in and out., Got a new fan but motor would not run it works fine ...

...fan is not running compessor & refrigerator case is running hot, fan is not running. replaced fan motor but, it still is not running need to know brand and model. which fan was replaced ( evap or ...

heater fan runs for a few min then shuts down Pilot stays lit, main burner lights, heats to fan cut in temp and fan starts. The fan runs for a few min then stops and the over temp safety cuts in and ...

my coolin fan wont come on wat should I do Cooling fan is controlled by a relay and a temp sensor. You need to check that each piece is working. Run power to the fan. fan run? fan ok. Bridge the relay

...fan is running loud. I am trying to figure out which fan it is? When I open the refrigerator door, the fan stops running. After I close the door, the fan resumes running several seconds after closing ...