...fan and the pulley pull off.You'll probably have to remove the top of the fan shroud to accomplish this. They are 2 separate pieces. I'd check a scrap yard for a replacement pulley. They will need to ...
...pulley belt on a 1997 cadillac seville sts Align belt on track as shown on the sticker on hood or radiator fan housing. There should be a diagram there. Then take a socket and breaker bar and either ...
...pulley. Both were 15mm bolts. I had to take the upper fan shroud off, and the fan and clutch off to get to the botttom bolt. Once loosened, pry the power steering pump/pulley closer and put the belt ...
fan is electrically operated using a thermal switch. To replace the accessory belt, you use a ratchet head to loosen the tensioner pulley, and slide the belt off one pulley, then release the tensioner
...fan shroud area but basically the grooved side goes against the grooved pulleys and the smooth side goes against the smooth pulleys relieve the tension by moving the idler pulley to make the belt ...
...then on the front a 13mm jack screw bolt, also difficult to access. Very important this belt be tight as it drives the fan pulley and the alternator is driven off the fan pulley. Take your ...
replace power steering pulley You can get a loaner pulley puller from autozone, and after you remove the belt you can pull the pulley. You may have to remove the fan and radiator to allow room to work
...fan pulley. Sometimes Cadillac does things a little different, so it's possible they may not all go over the fan pulley. You may also have grooves that aren't used depending on your options. ...
engine vibration 2000 deville check your engine mountings or the fan blades,or the crank shaft pulley or any other pulleys.
fan belt pulley chattering listen to tenioner and idler pulleys for bearing going/are bad also check all belt driven components for bearing/noise
Usually answered in minutes!
1,356 Questions
1,298 Questions
1,226 Questions
1,118 Questions
921 Questions
