Questions & Answers for: fan pulley

Ad

Question about 2002 TrailBlazer

3 Answers

fan belt on the water pump pulley. Use a LARGE pair of slip joint pliers to grasp the pulley (the belt will protect the pulley from damage by the pliers) while you remove the bolts. Be sure to install

Ad

Question about 1995 Grand Cherokee

1 Answer

...pulley attached 2 the fan and water pump moving as the fan rotates.......am I 2 replace the pulley, along with the water pump.....or will I be able 2 continue 2 use the pulley....and just replace the ...

Ad

pulley onto the fan housing. Before you remove the pulley you need to unwind the spring to be safe. Otherwise it will spring out on you. To do this pull about 6" - 12" of the cord out. There should be

...fan pulley) there are four nuts that you must remove at the front of the pulley between the fan. remove fan, fan shroud,loosen accessory belts. remove water pump pulley and the pump bolts will be ...

...fan pulley. Remove 4 cooling fan assembly bolts. Remove cooling fan assembly. Remove 4 bolts and upper timing belt cover. Remove 2 lower bolts and lower timing belt cover. Loosen adjusting bolt and ...

Question about 2004 Jetta

1 Answer

...Bora 2.0 5. The fan belt routing diagram for 2004 Volkswagen Bora 1.9 TDI CS = Crankshaft Gen = Alternator G = Guide pulley T = Tensioner pulley AC = Air Conditioning PAS = Power Assisted ...

Question about 2005 Ram 1500

1 Answer

...pully the water pump Hi, The water pump will be directly behind the fan pulley. The fan pulley mounts onto the water pump shaft. So no the fan pulley is not the water pump. Safe Journey's, ...

Question about 2005 Ram 1500

1 Answer

...pulley while you remove fan clutch bolt this procedure for checvrolet if you working on volkswagon you need spanner wrench hold the idler pulley while you use large wrench to loosen the large drive ...

Question about Duet 7.0 Cu. Ft. Super Capacity Plus Electric Dryer

1 Answer

...pulley onto blower fan housing i think you have to counter clock turn to put the pulley by hand. put you one hand inside the blower housing and hold the fan then use pliers and tight the pulley. now ...

...pulley directly behind the fan in the upper portion of the front of the engine. 2 Loosen the adjuster bolt on the tension pulley bracket. This bolt is on the left-hand side, situated in a long ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...