Questions & Answers for: kawasaki exhaust valve

exhaust valve. The valve doesn't seat all the way around and air/fuel mixture is getting into the exhaust header on the compression stroke and igniting from header heat. The reason this doesn't happen

...die and add a teaspoon of oil on the second test. If the compression amounts are the same, then its probably the valve seals. Good luck. If it's coming from the exhaust, then it's normally the

Valve setting procedure for this unit is a "go-no-go". By this I mean that for the intake valves a .02 feeler gauge will go but a .04 will not go. For the exhaust valves it is .04 will go and .06 will

...valve spacer and i reed block spacer the same thing? reed valves are in the intake rubber manifold, so the fuel mix can only go one way into the motor, Power valves are on the exhaust side of the ...

exhaust valve is allowing combustion gases to exit the combustion chamber and go out into the pipe.I would say that the valve is either damaged,not seated properly or both of the above.The only way to

ano ang tamang clearance ng valve intake at exhaust para sa kawasaki barako 175 pano kung pamasada po yung barako,ano po ba ang tamang valve timing nya? Intake .08 Exhaust .10

...exhaust was off i thought it must of dropped a valve so stripped it down and piston and valves are all of If it sounds like the exhaust is off, then is it possible that the exhaust has a hole in it? ...

...exhaust valve clearance for Izusu C240 engine what is the intake and exhaust valve clearance of an isuzu c240 engine online says 17mm of the feeler gauge for intake and exhaust valves,but are you ...

...Valve Clearance (when cold)" "Inlet: 0.13-0.18 mm" and that "Exhaust : 0.18-0.23 mm". Careful when doing the valves . on some bikes it changes the valve timing? i'd be contacting your bike shop and ...

...Exhaust 0.8mm 0.5mm Valve stem bend 0.05 mm TIR Valve stem diameter: Inlet 4.975 4.990 mm 4.96 mm Exhaust 4.955 4.970 mm 4.94 mm Valve guide inside diameter 5.000 5.01 2 mm 5.08 mm Valve/valve guide ...