Questions & Answers for: Chevrolet Suburban exhaust pipe

...exhaust pipe but not the oil I am wondering what the pipe that runs from rear of drivers side exhaust to the front of intake manifold is, and if would cause antifreeze consumption thru the exhaust? ...

Ad

Question about 1994 Suburban

1 Answer

to the motor from underneath, has two bolts holding starter in, flywheel cover over part of the starter and held in with 6 or 8 bolts. it's against the motor behind the exhaust manifold/lead down pipe

Ad

Question about 1987 Suburban

1 Answer

exhaust pipe loose at the manifold for test purposes. If it runs good with the pipes loose, that's the problem. Replace the Cat's. There were no codes for either, it would start and run nice for about

...exhaust pipe and as time goes by the welds break. Now, instead of the shield being welded in a couple places to secure it it's being held on by one or two welds and it rattles from time to time. I ...

IF YOU HAVE 4WD VECHICLE..DISCONNECT THE FRONT EXHAUST Y PIPE FROM THE ENGINE AND THE EXHAUST SYSTEM.YOU HAVE TO REMOVE OIL PAN SKID PLATE.AND THE LOWER CONTROL ARM CROSS MEMBER FROM BELOW THE OIL PAN

Question about 2007 Suburban Three-Quarter-Ton LS

1 Answer

...exhaust pipe, maybe there was a wire left off or a sensor was damaged when they changed from one to the other. If the diameter of the new exhause is too small and restricts the exhaust, it can affect ...

LOCATION OF O2 SENSOR ON 2001 CHEVY SUBURBAN o2 sensors are located in the exhaust pipe close to the manifold. Some have one, some have 2. It looks similiar to a spark plug.

...when there is no air coming out of the exhaust when running when the truck is running i cannot feel any air going out from the exhaust pipe either the cats plugged or you have a hole in the ...

...compression to the gasket ring between the exhaust manifold and exhaust pipe). This could throw off the oxygen sensor readings, resulting in an improper mixture, and would account for the

...sensor bank1 sensor 2 on 2007 tahoe Heated o2 sensor B1 sensor 2 is on the exhaust drivers side. Don't be surprised if you need to replace the complete Y-pipe with the catalytic converters

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...