...Oxygen sensors underneath the car? ussually on the exhaust pipe before the catalytic converter just after the exhaust manifolds. it will be sticking out of the pipe with one wire coming off of
If you are going to rivet or bolt in on you need to drill holes through both tip and exhaust pipe. I like having them welded on to prevent problems in the future. Any exhaust shop can do that for you
...exhaust pipe meet or at any of the joints on the exhaust pipes. or it could even be in the actul pipe itself. if you are on a tight budget you could go and ask a shop for an estimate on what it would ...
exhaust pipe. You will need a new oil pan gasket and a new exhaust pipe flange gasket. Put the car on ramps or jacks to access the undercarriage. Remove the exhaust pipe by removing the 3 nuts holding
...exhaust pipe behind the exhaust manifolds. Each mounts in the pipe much like a spark plug. They will have a connector that plugs into the engine wiring harness. Be careful not to strip the threads. ...
...exhaust pipe bracket loose from body and then take transmission dust shield off and unbolt starter and easily hold starter and disconnect wires from starter and then snake it out, then reinstall same ...
...exhaust pipe. BUT, the flanges on the ends of the pipe are called collectors. I hope this help and I will never visit London ;) muffler ?? do you mean the front silencer if so then its front pipe cat ...
...exhaust pipe while running Water coming from a exhaust is normal. The newer the car, the more emission control it has at protecting the environment and the more water you will see. Remember that the ...
Question about 1999 Yukon
exhaust out the drivers side pipe, going up hill the rpm's will go from 1700 to 2500 then it will shoot up to around 4500 Check the fuel pressure under a load and also do a exhaust back pressure test.
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions