Questions & Answers for: exhaust pipe

Ad

Question about 2005 Forenza

2 Answers

...pipe?to?exhaust manifold retaining nuts to 35 NSm (26 lb?ft). 7. Install the exhaust flex pipe retaining nuts to the catalytic converter or the connecting pipe. Tighten Tighten the exhaust flex ...

Ad

Question about 2005 Forenza

2 Answers

exhaust pipe spring loaded nuts.Radiator outlet pipe assembly to coolant pump cover bolts (2). Raise vehicle. Exhaust pipe from exhaust manifold. Pull down and back on the exhaust pipe to disengage it

Ad

...exhaust pipe to get to the @#$%^ing thing? Exhaust Crossover Pipe Replacement Removal Procedure Disconnect the battery ground (negative) cable. Remove the throttle body air inlet duct. Drain the ...

...Exhaust Pipe Flange Hold Down Spring 15 N802641-S2 Nut and Retainer 16 — Rear Heated Oxygen Sensor (HO2S) A — Tighten to 34-46 Nm (25-34 Lb-Ft) B — Tighten to 20-25 Nm (15-19 Lb-Ft) C — Tighten to ...

Question about 1993 Cutlass Ciera

1 Answer

...exhaust pipe, do u have a loud (more than usual) exhaust sound, if so, the exhaust pipe is cracked or split, if not, then the exhaust hangers (mahe of heavy duty rubber) are split/broken, causing it ...

...exhaust pipe. Best thing to do is find an exhaust shop that can go in and weld the pipes back together. If you broke one of your exhaust hangers and the pipes are lower than they should be they can ...

...exhaust pipe to the engine block. Remove the 2 screws that hold that bracket on. I think they are 12mm heads. Detach the 2 exhaust manifold to exhaust pipe screws, the screws have 15mm heads. A 15mm ...

Question about 2002 Rendezvous

1 Answer

...exhaust crossover pipe. Below I've included removal and installation instructions. Also, the procedure for bleeding the coolant system is critical; if you need those instructions please post the ...

Question about 2002 Rendezvous

1 Answer

...Pipe to exhaust manifoldnuts 18 Lb/Ft.(AIR) Pipe to exhaust manifold studs 4 Lb/Ft.Exhaust manifold AIR pipe studs 4 Lb/Ft.Note:To torque bolts and nuts, start in center usingcrisscross pattern ...

...exhaust pipe. Support the engine cradle with screw jacks and remove the rear cradle bolts. Loosen the front cradle bolts and slightly lower the Engine cradle. Remove the remaining exhaust ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...