Questions & Answers for: exhaust clamp

...clamp at the exhaust manifold and remove the converter from the engine compartment. You may need to replace these clamps after removal because you need to pry it apart and they will leak when you ...

Ad

...clamp on and you should be all set. The muffler tape is only used to help prevent an exhaust leak at that joint. However you may want to examine the muffler itself since they have a tendency of ...

Ad

...exhaust closet to the dounut. this should give you enoun slack to move the pipe. Assuming your clamp bolts will loosen. Loosen bolts on the doughnuts clamp. remove the clamp. Then pry the tail pipe ...

...starting sounds like exaust is hitting body also when driving over bumps on road Possible that the exhaust connection glands are worn out or the clamps are loose so that the exhaust is hanging down ...

Question about 1998 Grand Cherokee

1 Answer

how to change the tailpipe on a 98 grand cherokee thier should exhaust clamps on the exhaust just loosen the clamps and take the o2 sensor out of the converter then unhook the rubber support from the ...

...is re-attach the exhaust pipe and tighten the clamp? Some cars don't need donuts. Look at the exhaust manifold and check if it is coned shaped. If it is then you don't need the donut

Question about 1989 240

1 Answer

...Hissing sound comes from the motor end,near the turbo but not sure sounds like air escaping, or exhausted leak, So what is a valve leak I WOULD BE CHECKING THE CLAMPS ON THE INTAKE HOSES FOR

Question about 2005 FLHTC - FLHTCI Electra Glide classic

1 Answer

...exhaust bracket clamp bolt to 60-96 in-lbs (6.8-10.8 Nm), tighten the two bolts with lockwashers, tighten the four TORCA clamps to 45-60 ft-lbs (61- 81 Nm) in the following order, crossover pipe to ...

Question about Waverunner Xl 800 / Xlt 1200 Jet Ski Pwc Cover

1 Answer

...exhaust to come out , then at the rear of the engine there is another clamp , totally remove it also ! Then release the clip at the point where the exhaust goes through the bulk head and you should ...

How do I stop exhaust system rattle on Honda CR-V? heat shield rattles I put large hose clamps around exhaust shields that have cracked or rusted thru. Easy fix to do. You can put 2 clamps together to

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...