when the treadmill is running at a speed above 7.0 , it hangs ...what is the solution for it replace the drive belt under the motor hood what is error code 2
ERROR CODE E 7 Have you tried to recalibrate the unit? Walking belt sticky at all? Smell anything? Does this use a red dc motor? If so, check for a burnt "choke" (looks like a small transformer near ...
...error code E7. What is the problem ? Hi, By E7 it means Speed sensor feedback missing. You have to check the speed sensor mounted near the motor pully. Remove the speed sensor and clean it well Then ...
...error codes, if necessary for club or personal logging purposes. 4 To view the treadmill's odometer reading when a particular error code was elicited, press "SELECT" while a particular error code ...
...error code 1 my treadmill starts and soon after stops, error code 1 is displayed see the diagram attached for the speed sensor. test for open or faulty. clean it, and tight for plug or connector. 2) ...
...stays up on the and the treadmill will not start hi, Here i have added the list of error codes list for t5x . Check the same and confirm which error its shows. error 02A0 is not listed any where. ...
...treadmill back into the wall, and turn on..... Now try to hit GO or Start and see if the unit runs with no error. If so, you have either a bad feedback sensor or bad wire. Matrix had huge issues with ...
Error code E3 on my treadmill
Usually answered in minutes!
21 Questions
7 Questions
13 Questions
2 Questions
1 Questions