Questions & Answers for: Buick LeSabre error 42

Ad

1990 Buick is cranking but not starting. replaced coil pack and fuel filter with 42 lbs of fuel pressure. Need Help!! Need to know if there is a spark? If there is a spark check the modular which is ...

Ad

...42. What does this indicate? ignition control [ic] error check the wiring and connections on the ignition control module usually located on the passenger side of engine by crankshaft position sensor ...

Ad

Question about 1992 LeSabre

1 Answer

My 2002 buick lesabre stalls when I step on the gas. It idles just fine. I put a fuel injector tester on it, and it read 42 PSI with the key on. I started the motor and it read 42 - 43 PSI at idle. I ...

door label is missing...what are recommended front and back tire pressures for 2004 lesabre limited? 2 to 4 lbs below the Max on sidewall of tire 38 back 40 to 42 front That door label is used by the ...

Question about 1992 LeSabre

1 Answer

i get a code 42 after driving car for a while, but if i shut off car the service engine soon light goes out. i have change the ecm,the ignition module, and coil pack, still have the same code issue ...

Question about 1993 LeSabre

1 Answer

93BUICK H BODY 3.8, CODE 42, HELP! OWNER CALLED SAID CAR RUNNING ROUGH, WILL TRY TO GET IT TO THE SHOP. OWNER SAID CEL CAME ON ENGINE SMOOTHED OUT, CHECK FOR CODES FOUND CODE 42, CLEAR CODE, START ...

88 buick Lesabre dtc 42 and 44 car stall once a while starts right up again Check the condition and operation of the idle control valve.

Question about 1992 LeSabre

1 Answer

what does code 42 mean ok ran a code reader it said code 42 could be electronic spark timing circuit open or shorted to ground during engine run or direct igmition system bypass circuit open or ...

A/C Blows Cold On Right Side...And Hot on Driver Side???? don't know why This Is But Blows 42 Degrees on Pass side And hot On driver Side. stuck flap under dash.

Question about 2005 LeSabre Custom

1 Answer

CAR BUCKS AT DIFFERENT SPEEDS HOW CAN YOU HELP Check the spark plugs and leads plug gap must be 1.0 mm or 42 thou gap.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,706 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,573 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,066 Questions

1994 Buick LeSabre
1994 Buick LeSabre

891 Questions

1998 Buick LeSabre
1998 Buick LeSabre

884 Questions

Manuals & User Guides

Loading...