Error code 1 2 After the green blinking light. I pushed device and menu and got an error code of 1 2. Then I pushed the power button and the TV worked. if it does it again i would check for bad caps ...
...error 1 2? I found this list of codes Error Code Probable Cause 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan ...
...2 blinks, a pause, and 1 blink of the status light. Any ideas? Thanks they dont have a 21 error they do have a 12 and a 22 error code. 12 means normal no error detecteced 22 is momentary upset after ...
Question about WD-65732 65" Projection HDTV
2 year old Mitsubishi 65 inch DLP will not turn on. I tried to turn it on last night and the tv seemed to power up but no picture was present. I tried to reset, and the same thing happened. I examined
Question about WD-62525 62" Rear Projection HDTV
...Error Code. ? The flashing then pauses for approximately 1/2 second. ? The LED then flashes indicating the value of the LSD (ones digit) of the Error Code. Example: If the Error Code is ?32?, the LED ...
Question about WD-52525 52" Rear Projection HDTV
...2 different short codes. It seems to blink 13 times Don't need error codes for this one if the green light is flashing all of the time then you have a bunch of capacitors that have gone bad on the ...
...Error Code. • The flashing then pauses for approximately 1/2 second. • The LED then flashes indicating the value of the LSD (ones digit) of the Error Code. • The Error Code ...
Question about WD-52525 52" Rear Projection HDTV
...error code is "42" the led will flash 4 times pause and flash 2 times and it will cycle for a total of 5 times.Please let me know what is the error code.If you can't access the error code mode ...
Question about WD-52525 52" Rear Projection HDTV
...Error Code. • The flashing then pauses for approximately 1/2 second. • The LED then flashes indicating the value of the LSD (ones digit) of the Error Code. • The Error Code is repeated a total of 5 ...
...error code 42? WD-65C10 DLP TV BLINKS RED 4 TIMES AND YELLOW 2 TIMES? I think this is a DLP tv and has a special fan deep inside the works. I think, not sure, but you can google around to find more ...
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions