Questions & Answers for: Harley Davidson FXST Softail Standard error 10 94

Replaced positive battery cable + spark=bike will not fire up HD-Softail 94 Replaced positive battery cable + spark plugs=still can't start the bike (making clicking noise while pressing start ...

Ad

Question about 2000 FXST Softail Standard

1 Answer

I have changed 3 pinion gears in a few months on my 1996 evo. Maybe it's when backfire and kick back the ring gear clutch and break... i need a solution NOW....... thanx I'm assuming the gear you are ...

Ad

Question about 2000 FXST Softail Standard

1 Answer

...10 k service at that time and the issue seemed to go away until this past week. It is more inclined to do this after it has warmed up. The flashing lights "Engine light comes on intermittently and ...

Question about 2003 FXST Softail Standard

1 Answer

where can i get a diagram of my 2005 fxdci for turn signals I have a drawing of a '94 FXDWG turn signal unit. The units are the same but the wire colors might be a bit different. If you'll contact me ...

Question about 2003 FXST Softail Standard

1 Answer

1991 harley fxstc starter was just clicking once and found ground on battery loose. also the post on the battery melted a little. now the starter will make a ratcheting sound but wont start the bike ...

Question about 2003 FXST Softail Standard

1 Answer

I need to know what i need to torque the rocker box and the rocker underneath the covers to also The bolts for the lower rocker plate are torqued to these specs: 5/16 inch bolts - 15-18 Ft. Lbs. 1/4 ...

Question about 2002 FXST Softail Standard

1 Answer

need torque specification for outer primary cover 9-10 foot pounds. Steve

I have a 94 Softail Custom and the fours ways and turn signals blink on their own while riding. I have taken the tank off and checked all the wires but can not find any bad wires. I have re-wired the ...

Question about 2000 FXST Softail Standard

0 Answer

I have a 2000 softail, after running for 10 minutes it dies,then sits for 10 min. then will start again but only run for another 2 min until it dies again Hi Anonymous, and the usual suspects are: 1. ...

Question about 2003 FXST Softail Standard

1 Answer

...error 5 Current 63 ECM serial data low 6 Current 63 ECM serial data open/high 7 Current 63 TSSM serial data low 8 Current 63 TSSM serial data open/high 9 Current 61 Loss of TSM/TSSM serial data 10 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...