Questions & Answers for: error 1060 Ovens

Ad

error F2 mean? the f2 code means the their is a problem with the oven sensor the sensor is a electronic thermostat if you know where to find in to check it unplug it and insert meter leads set to ohms

Ad

...error code means the oven tempature sensor has became defictive and needs to be replaced. You can clear the code buy pushing the stop/clear button,and try to use the oven again if no code all is ...

Ad

Question about JTP15 Electric Single Oven

1 Answer

1060-1100 ohms at room tempature. 16 ohms the new sensor is shorted the F2/F3/F4 all relate a faided sensor and the F5 error code says the clock (electronic oven control) is defective. Test the sensor

Question about JTP15 Electric Single Oven

1 Answer

error code means that the heated well above the setting the tempature was set at. The usual reason the oven would over heat by so much is a defective oven tempature sensor and the sensor would need to

Question about RBS275PD Electric Single Oven

1 Answer

...error code means that the over overheated by at least 100 degrees above the tempature that was set at the time. The usual reason the oven would over heat by so much is a defective oven tempature ...

Question about AOCS3040 Electric Single Oven

1 Answer

...error code means that the over overheated by at least 100 degrees above the tempature that was set at the time. The usual reason the oven would over heat by so much is a defective oven tempature ...

Question about AOCS3040 Electric Single Oven

1 Answer

...1060-1100 ohms of resistiance when its good.The F4 error code is for sensor that has a open circuit,so instead of the 1060-1100 of a good it the display on the meter will show infinate resistiance ( ...

Question about RBS275PD Electric Single Oven

2 Answers

...error code means that the oven temperature was higher than it's supposed to be. Usually the oven overheats because of a defective oven temperature sensor and the sensor should be checked. this is ...

Question about RBS275PD Electric Single Oven

1 Answer

...1060-1100 of a good one.The F4 error code is for sensor that has a open circuit,so instead of the 1060-1100 of a good it the display on the meter will show infinate resistiance ( the meter display ...

Question about RBS275PD Electric Single Oven

1 Answer

...1060 ohms. Manual said 1100 @ room temp so.... Hi – Typically error code F3 indicates a faulty sensor probe or wiring harness between sensor probe and EOC. Try resetting the range by unplugging it or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...