...also is no cover over the bulb aned I can't tell if it had one originally or not.- they do make an epoxy repair kit at whirpool but its about $100, six bucks at the hardware store wpuld get a good ...
Question about GS6NBEXR Side by Side Refrigerator
...noted. HI thanks for your question. its the door liner, that's broken, if you can repair with some epoxy puddy, only problem with epoxy puddy , it smells. so the door liner is to be replaced. thanks ...
...around $30.00 Save yourself some cash and have something handy around. Go buy a good 2 part marine epoxy. Mix it in equal parts and use an old spatula or popsicle stick to work the epoxy into the ...
Question about Calypso GVW9959K Top Load Washer
...with very course steel wool or 80 grit sandpaper after the surface has dried to prepare it for an epoxy patch. If possible you need to also prepare the inside of the leak as well and also apply
Question about Calypso GVW9959K Top Load Washer
...the panel will slide out, some have different color on back, or take outside and paint with an epoxy appliance
Question about 24 in. DU1100XTP Built-in Dishwasher
...wipe the bottom of the granite and the top of the clip with acetone, then use a gel-type two part epoxy from your local hardware store to attach the clip to the granite. Use enough to make the
...This can be repaired by replacing the counterweight part, or by strongbacking with aluminum, and epoxying the weight back into a solid mass. Epoxy also is useful for repairing cracks in tubs. I ...
...have enough surface area to work with, you can repair the plastic where the screws go with two part epoxy. You can get it in a package that looks like a big double barreled syringe. Take the switch ...
Question about Duet GHW9150P Front Load Washer
...the plastic tab that the start button was attached to had broken off from the panel. Used a good epoxy to glue the edges back together and it works like new. Also broke two tabs that hold the LED ...
Question about Duet GHW9150P Front Load Washer
...know what newer ones are made of. I use "J B Weld" on steel, and there is another brand that makes epoxy steel also. On anything else, I would use a straight epoxy, where you mix resin and hardener. ...
Usually answered in minutes!
1,894 Questions
803 Questions
611 Questions
487 Questions
348 Questions