...Con and fan blower fault 2004 reg Renault Clio Sport 2004 - Everything working fine until I stopped engine for about half hour on return found no demist or air con working. all front panel ...
...do i set the timing on my 1.4i kangoo 2003 model? i see yhe marks on the pulley's but not on the engine! Thats cause theres no distributor, ignition is all electronicaly controled now through the
wrong? If engine will not turn over after head refit,make sure all timing marks are aligned when timing belt was refitted.If it will not turn over using socket/spanner on crank ,then thats the problem
timing mark is on flywheel ,,hole through the engine side of the bell housing for a special tool ,or a long 8mm bolt ,if memory serves me well the cam has a 8 mm hole and locating hole on head ,common
...engine over on starter with a big bar on the pulley nut ,then change the belt then with assistant holding a snap on heel bar in the flywheel ring gear whilst i hammer the bottom pulley bolt with the ...
...timing ,where a bolt is removed in the bottom of the block just infront of the bell housing at the front of the engine and a special bolt put in that locates the crankshaft.Now their is no crankshaft ...
...timing marks. now my question is where can the timing marks be seen, detailed procedures positioned for the crankshaft, cam, and when the crankshaft is put to position, what is the pison position. ...
Question about 2000 181
...engine running Hi Oulmide, Make sure of the correct setting of the valve and crankshaft timing match marks. Inspect both sensors for correct operation (crank and cam shaft sensors) as it may be that ...
...timing snapped, Every engine has a method for aligning the cam-to-crank for installing timing belts/chains. On a dual-Camshaft Renault there will be a mark on each of the camshaft pulleys - the ...
Usually answered in minutes!
774 Questions
410 Questions
331 Questions
150 Questions
