timing tab and the engine is in #1 firing position. To adjust a valve back off the adjusting nut until lash is felt at the pushrod. Tighten the nut until all lash is removed. This can be determined by
engine , first i turned the crankshaft and lined the mark up with the mark on the block because there is no timing indicator on the front of the block,so the i installed the distributor with the rotor
engine it would turn over but not fire up , so i figured the timing was off from replacing the distributor so i waited until the next day to continue and to my suprise the engine wont turn over , so i
...to replace the liftgate fuse, it is marked "ECC" fuse in the fuse panel. The row closest to the engine at the bottom. Should be a ...
...harm the engine. If your timing is out enough to "ping", yes it can harm it. Your timing marks should be at the harmonic balancer, with a little plate with numbers on it, at the top of the
...timing wire in my engine compartment Good Evening, I have run into this a time before there are a couple places, one of course in the engine compartment by the firewall, the second location is behind ...
...engine light. needed smog for dmv registration renewal. fault code P1345. what is needed to get it to pass smog check? The vehicle need to be timed.If you had a intake done this should have been done ...
timing marks on engine and the dis is at 2 # okay, did you have these items out of motor or did it quit running and this is what you have checked? I can fix this problem but i dont know where to start
...timing mark tab and did not turn engine before checking the marks the balancer is spun and needs to be replkaced if the engine has been turned it may be 180 degrees out of time you will ...
...Timing gears usually have a pair of marks that line up adjacent to each other when correct. Turn the engine by hand when making any adjustment to prevent valve train damage. If you are not sure what ...
Usually answered in minutes!
904 Questions
942 Questions
867 Questions
830 Questions
647 Questions