Questions & Answers for: Nissan Hardbody engine stalls ideling

Question about Nissan Hardbody

2 Answers

...switch(motor/servo) which induces a higher idle during warm-up. Without this availability the engine is being fed extra fuel and relying on a slower idle speed which results in stalling. Thank ...

Ad

My 1997 nissan pick up stalls out and engine dies when engine heat goes up to or near normal operating level. It idels and runs good when the engine is cold check the coolant temperature sensor.

Ad

Question about 1989 Hardbody King

2 Answers

Can't Pass Emission Testing because High Hydrocarbons and some shaking and stalling on cold engine starts. Give it a tune up,change air and oil filter and oil.Put preimium gas in the tank. And change ...

Question about 1989 Hardbody King

1 Answer

1989 2.4 nissan d-21 pick up. running good and then just cut off. have spark, compression, and time, and fuel {not sure if enough fuel} turns over and acts like it wants to crank. Finally did crank ...

Question about 1989 Hardbody King

1 Answer

I have a 1996 nissan truck,the d21 series engine. I went to two different parts stores to find that the thermostat for that engine was larger than the one I removed from my truck. Everything is ...

Question about 1989 Hardbody King

1 Answer

...be taken during cold starting If the vehicle is an manual gearbox, hold the clutch in until the engine has taken properly. If it is a manual rather start i neutral with the park brake on than in ...

Question about 1989 Hardbody King

1 Answer

...cause or if at all that was the real problem. Please help Possible faults:- Coolant sensor - engine is signaled as being 'cold' all the time, not just at start up, causing ECU to set longer ...

Question about 1989 Hardbody King

1 Answer

...engine stalls sporadically Just replaced, plugs , points, plugwires,new gasket on carb/injector, set timing etc. Runs strong and smooth but without reason the engine will die. Restarts easily, no ...

i need the firing order and layout diagram for td 27 engine td 27 engine In long method firing order 1-3-4-2 nissan td27 engine how many degree did you turn the crankshaft pulley?

I NEED TO KNOW THE ENGINE CAPACITY OF AN ENGINE NISSAN ENGINE NUMBER YD25528467Y The YD engine is a 2.2 L & 2.5 L I4 diesel engine

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...