Question about 2000 Taurus
...engine noise. Makes a loud engine noise. Does not run hot. Runs very good. Has the following specs: 4.6, 8 cylinder engine. Noise comes from the bottom of the engine. Runs almost quiet in Reverse and ...
...noise in engine I have a 1992 Ford F150 V8, 302 engine. There is a ticking noise in the right side of the engine compartment under the hood. The engine is a replacement motor purchased from Ford and ...
...engine made a loud clacking noise. Almost sounds like an old dieselk engine. Has my motor blown? I have checked all the fluids and all are full. timeing has slipped or cam broken WHERE DID THE NOISE ...
...noise dissapear when engine warm up .2000 Ford taurus SE You problem is most likely just lifter noise. This is common with a lot of Ford engines with self adjusting lifters. Although lifter noise is ...
...engine noise that seems to be cam related or located ower engine. The problem is intermittent sometimes there is no noise then sometimes the engine seems make noise loudly. During the summer when I ...
...noise. Shut engine off immediately. The oil light flickers on dash with engine running. Do fuel injectors make tapping noises when degraded? Is it possible hydraulic lifter not able to leak down or ...
2011/08/how-to-perform-basic-engine-tune-up-oil.html---------Rattle noise from engine? http://whatisbyme.blogspot.in/2012/05/2005-toyota-corolla-rattle-noise-from.html-----------These will help.Thanks
Question about 2002 Escape
noise at high engine speed even when sitting still. could be anything from belt noise idle pulley noise to lifters or injector noise is it a knocking noise is your check engine lite on I think I would
Question about 2002 Escape
noise ft of engine .sounds like center of engine.has new cam and lifters and new rods and mains at idle pull plug wires does not change noise Try running it for a short while with the belts off to see
...noise Engine Noises ' Knocking and Ticking ' Common Causes www.justautorepair.com/whats-wrong-with-my.../knocking-ticking The following are causes of connecting rod bearing noise: ... Loose torque ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions