Questions & Answers for: Volkswagen Passat engine block

block in the engine? for WV p-variant 95 the engine start only whit original key, with another key the engine start but after 3 - 4 sec. it stops. What it's the problem and how can i resolvit? I whant

Truck does not start unless I use engine blockheater even in summ Truck does not start unless I use engine block heater u need new glow plugs a set of four

engine block, where it meets teh block you will see the housing. It looks like this http://www.drivewire.com/search/?Ntt=Thermostat+housing&N=0&uts=true&t_event=true Be sure and be careful

...engine block just to the side of the water pump underneath the housing where the upper radiator hose is attached. Remove the lower engine shield. Place a large drain pan under the vehicle to collect ...

...-- the housing that attaches to the engine block, and onto which the oil filter screws to. Is this an easy item to replace? You may need a new gasket to the block, or it may be the cooler

...engine? The square aluminium block on the left side of the engine is the oil cooler (water/oil heat exchanger). The oil filter is placed inside the aluminium cylinder block above the square aluminium ...

...sector of the engine block, near the flywheel.This will be on the AAA engine build. On the ABA build, The crankshaft position sensor is mounted on the side of the engine block, near the crank

Where is the crankshaft position sensor located in a 2002 VW Passat GLX 2.8l on the engine block next to the left engine mount.

...engine block but you have lots of opsticals in your way its best to remove your alternator the you will have better acess to it you will see a black plastic elbow pype coming out of block you need to ...

...to replace the clutch? I cant reach the last 3 bolts holding the transaxle to the engine block.They are blocked by the frame. You gone have to loosen up 2 engine supports so it can go down ...