Questions & Answers for: Dodge Durango engine block

...section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to whatever the factory spec is or it can cause it throw another

...car and weather - Low oil level - loose oil cap or dip stick seal - Leaking oil gaskets or engine seals (common in old cars) - Blocked oil filter - Faulty oil pump or block internal oil pump ...

...ENGINE RUNS AT RIGHT TEMP SOUNDS LIKE YOU MAY HAVE AIR BLOCK, OR BLOCKED HEATER MATRIX, CHECK FIRST CHECK THE HEIGHT OF THE HEATER MATRIX IN THE CAB , IF ITS HIGHER THAN THE FILLER/EXPANSION TANK. ...

there is oil come,ing out of the exhust why but the engine seems to be running well did you check your oil level??.if you put to much oil in the engine it cause a lot of damage.But if oil levels are ...

...engine oil pressure sensor in the 4.7 engine locate engine oil pressure sensor in the engine Which engine do you have? In either case, the sender is threaded into the block near to the oil

...ENGINE...HAD WATER THOUGH,,,NOW WATER GOOING TO ENGINGE...OIL WHITE MILKY LOOKING You have an internal water leak somewhere. Question for you; did the vehichle run hot prior to this ? If your answer ...

BLOCK the system needs a/blead air in the system.look at the top of engine and find a outlet at the top of the water system and with engine idleing open and let all air out then close keep doing until

...engine block. if your engine is newly overhauled then it may show an increase in temp till the working parts become free. to make the parts free keep the engine started and the vehicle stationary ...

...V-8 the sensor is located on the passenger side(near the rear) of the engine block . If its a 5.9L V-8 its located on passenger side between transmission and engine block (behind the cylinder

where are soft plugs In the side of the engine block , when a engine is casted those holes are where they get the casting material out of the block ! How It Made Engine Blocks