Questions & Answers for: Buick Roadmaster engine block

...sides of the block with plumbing and accessories blocking access. There are also some on the rear surface of the block, which usually require separating the transmission from the engine to

...engine block near the intake, it tells the engine what your oil pressure is. The oil pressure switch is the component that will shut your car off if the oil pressure gets to a dangerous low or high. ...

fuel pump problem 50 buick fuel pump has been replaced but wont pump gas as if its blocked so the engine will turn over but wont start because its not getting any gas The vehicle is a 1950? If so it ...

...engine block. There may or may not be shims placed between the starter and the block. DON'T LOSE THOSE SHIMS! There is also a bracket with a stud and nut that supports the front end of the starter. ...

locatio of oil sending unit on a 94 buick road master Hi, This is at the very rear of the engine block on the top in the middle. Thanks Jason

...the cylinder heads installed on it. That's one way of buying an engine. Along block is the same as a short block except it does have the cylinder heads and maybe the intake manifold as

block engine 350 motor? The '92 Buick Roadmaster is equipped with a 5.7L TBI 8 cylinder engine. The 5.7 is the 350 CID. When you inquire about a "short block" however, that is not what is in your car.

...block It might be the coolant in your car, or it could be the window washing fluid. There is a lea for sure if there is water coming off of it. Just to be safe you want to take it in a get your hoses ...

...engine oil & one for the trans. fluid. There's also a one wire (Thermistor ?) type sensor in a junction block in one of the lines coming out of the trans. Can't find a word about its function. I ...

...engine block to ensure they have not started to come out. If one should fail when driving, you will lose all your coolant in seconds. However, if you are having cranking issues, you may already have ...