...the back of the engine block about in the middle of the motor..There might be one in the front of the engine in the middle of the block but most are in back.Hope this helps you and have a great
...engine block. Here is a picture of what you are looking for to help you out: It basically looks like a big nut with an electrical plug-in in the end of it. Please let me know if you have any more ...
...engine block and there you should see a neck where the hose is connected to the engine block. 2. Take the hose off by removing/loosening the clamp and pulling the hose off. Sometimes it's easier to ...
...engine. If prying is necessary, use a protected blade; take great care not to damage the mating surfaces of the head and block. Clean the head and block of all gasket material. Take great care not to ...
...new head gasket (Best case) or the block, or piston sleeve, or head is cracked. If cracked block or sleeve, then you need a new engine. If head or head gasket, then you only need those parts
Question about 2005 ES330
Lexus es330 engine check in view because i have changed fuel filter and it take time start the engine this vehicle may be due for a service.slow starting in colder weather can be due to many issues. ...
...a clicking sound - engine check codes are P0300, P0301, P0303, P0305 All of these codes are misfire codes.clicking sound is most likely spark jump from plug wires to metal(head,block,valve cover
...on rx350 The block heater is installed at the front of the engine to the left. Depending on where you choose to leave the cable, it could be under the bumper, or hanging near the battery or
Question about 2002 ES 300
...block without pulling the engine? 3.0l 1MZ-FE. the main caps have bolts that go in the sides through the block. Is there a way to get these bolts out without pulling the motor. Sorry, The engine must ...
Usually answered in minutes!
531 Questions
449 Questions
430 Questions
363 Questions
362 Questions