...Encoder strip is Dirty. 4. Encoder strip is Out of position. Solution: 1. Open the front cover and check if ink cartridges lids are properly snapped in. 2. Turn the printer off and pull out the power ...
...Encoder strip is Dirty. 4. Encoder strip is Out of position. Solution: 1. Open the front cover and check if ink cartridges lids are properly snapped in. 2. Turn the printer off and pull out the power ...
...Encoder strip is Dirty. 4. Encoder strip is Out of position. Solution: 1. Open the front cover and check if ink cartridges lids are properly snapped in. 2. Turn the printer off and pull out the power ...
...Encoder strip is broken or its out of printer . However if you see encoder strip inside the printer connected from left to right, try these steps. Solution: 1. Cleaning the encoder strip: a. printer ...
...Encoder strip is Dirty. 4. Encoder strip is Out of position. Solution: 1. Open the front cover and check if ink cartridges lids are properly snapped in. 2. Turn the printer off and pull out the power ...
...Encoder strip is Dirty. 4. Encoder strip is Out of position. Solution: 1. Open the front cover and check if ink cartridges lids are properly snapped in. 2. Turn the printer off and pull out the power ...
Question about PSC 1510 All-In-One InkJet Printer
THE PRINTER CARRIAGE GOES TO THE RIGHT AND WILL NOT RESET, THE YELLOW LIGHTS COMES ON, AND THE ERROR MESSAGE SAYS PRINTER CARTAGE IS STUCK. It may be that the encoding sensor or encoding strip may be ...
...encoder strip Gently move the top part of the printer belt to the right. Using your index finger, gently push encoder strip down and then back up to get it back into the slot located on the back of ...
...Encoder strip on a designjet 500 24" 1. Remove the left hand cover 2. Remove the right hand cover 3. Remove 1 T15 screw that secures the Encoder strip to the left encoder holder 4. Release the ...
Encoder Strip on the A940 All-In-One Printer To reposition the encoder strip, perform the following steps: Remove the power cord from the unit. Lift the lid of the unit, just below the scanner portion
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions