...be hard to eject. The VCR may be very difficult to get out to work on, and I doubt that it is a broken or loose belt that is causing your symptoms so you will probably be better off just replacing
eject????????????? The tape gets stuck because the mechanism has slippery bands in the gears. A maintenance is needed and if the rubber bands are old better to get them new. To do this job the set has
...eject button while the unit is starting up. Do this a couple of times. If the above did not work, or there is no disk stuck inside, then wiring to unit motor, or mechanics may be broken. In that case ...
eject button is pressed. Are you getting any messages on the display. door is either jammed or the belt is broken inside that operates the door...also , there may be a possibility that the door is out
...Close and let it start loading. If it doesn't load, eject the DVD and note it's position. If it hasn't moved iit could be either a broken belt or the drive motor I think>
...eject tape? Always frustrating when a videotape gets stuck in a failing/failed VCR deck. Since all decks use a loading motor and gear system, it would be a simple matter of gaining access to the ...
dvd tray will not open dvd will not eject,it says open. Helloeither its loading motor has damaged, or its loading belt has broken. Check these.
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions