Questions & Answers for: Chevrolet Venture ect

Question about 1997 Venture

1 Answer

where is temp sensor for fans located on 2002 chevy venture van the computer turns the cooling fan , using the ECT sensior in on the manifold

Ad

Question about 2000 Venture

3 Answers

like you may have a headgasket problem and steam cannot heat the coolant sensor.OperationNotesThe electric cooling fan operates when the engine cooling temperature exceeds a certain value. The cooling

Ad

Question about 1997 Venture

1 Answer

Location of ECT on A Chevy truck located in thermostat housing or in intake nearby (where top hose connects from radiator to engine)

Question about 1997 Venture

1 Answer

just replaced ect sensor in 04 pontiac montana with 3.4 motor after the engine would run hotter than normal, but not overheat. temp goes down while driving but climbs slowly at idle until fans kick on

Question about 2002 Venture Passanger

1 Answer

...(Coolant Temperature Below Thermostat Regulating Temperature) This means that the engine's PCM detected that the engine has not reached the required temperature level within a specified amount of ...

Question about 2002 Venture Passanger

1 Answer

...outside? I had driven appx 8 miles before the light came on. This means that the engine's PCM detected that the engine has not reached the required temperature level within a specified amount of ...

Question about 1997 Venture

1 Answer

AC WILL NOT TURN ON WILL RUN BY USING SCAN TOOL {: ) When an A/C mode is selected, the A/C control head or the A/C programmer supplies a 12 volt signal to the PCM A/C request input. The A/C compressor

Question about 1999 Venture

1 Answer

...AC unit with r134a , can be bought at a variety of places.. Autozone, O'reileys, napa, home depot.. ect...ect. Hope this works for you! good ...

...on defroster, gauge will not register a temp. Cooling fans do not go on when AC is on. Disconnect ECT sensor and cooling fans go on. Suspect a faulty ECT, but any help or guidance would be ...

...restriction to the map sensor--a skewed map sensor reading can cause the PCM to read an incorrect MAP change during the EGR flow test an engine that is running poorly due to mechanical

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...