Questions & Answers for: ecm mod

...mod 1996 dtc codes, i look to the ecm and does not have any switch to change to self-diagnostic mode. thank you There is a connector under the steering column, you need to buy an OBD 2 system scanner ...

...Mod & pick-up. All showed to be bad with OHM meter. 20A ECM-B fuse keeps blowing out and I'm afraid to burn these new parts up.... ANY IDEAS OUT THERE??? The 20A ECM-B fuse was bad replaced and ...

to normal operating temp I have replaced the coils and mod under the coils also has new tps and idle air sensor and new rebuilt Ecm no codes on Ecm check the crank shaft sensor.need a scanner to do it

...ECM-B fuse. Replaced Ign Mod,Coil,Cap/Rotor & pickup. Any Ideas Out There? Afraid to go any futher...dont want to ruin these new parts! if you keep blowing a fuse there's a good chance it's not a ...

...other than pipes? Second depending on your mods you may just want to stick with your stock ECM and touch base will your local Harley shop about downloads or MAPS available for the mods (for ...

...off idle. ichecked the ecm and the code i got back was uo100 lost conn w ecm/pcm mod a any advice ? I believe the 02 sensor is on death row. have it chked or change. Good luck. Changed is

...ECM,fuses,relays even got new injectors still cannot get my injectors to turn on Hi there, Joel here 20 year master mechanic. For the faulting to the injector pulse and power, the control mod in the ...

...ecm spy map for buell 2007 xb12s with micron ex', K&N air filter and breather mod' Americansportbike.com has map for that setup. I have it on my bike also with a Micron/K&N/breather ...

...control module location if the engine control mod burned does that prevent the vehicle from starting? Yes if the ECM is defective the car wont start, the ECM controls the fuel injection, spark ...

...MOD $00 I would try disconnecting battery again. Disconnect both cables and touch them together for a few seconds. This will reset all modules. Wierd that you had so many codes after just ...