Questions & Answers for: Kia Sedona earth leads

in repairs! I'm afraid to say it is most likely the circuit board shorting out but may be trace the earth point to the chassis. It's often a bad ground that causes faults. After this - check bulbs and

how do i change the spark plugs on 2003 kia sedona van there is a big cover, that needs to be removed. is this some thing i can do? any special tools needed? Hey bobnatboys, The back 3 spark plugs are

...earth cables/leads too these are thinner and connect at car body and to engine these are common faults that affect the various sensors for engine half the time due to poor or corroded connections to ...

Kia Sedona won't start even with a new battery. This is just since the cold weather. It did start a couple of times with jumper leads. is it the 2.9 crdi?? if so it will be the glow plug timer relays.

...earth leads where they connect to the Battery Terminals, Engine and Body. If possible disconnect, clean thoroughly by removing any corrosion or paint that could cause a poor connection, and reconnect ...

2003 kia sedona wont charge battery with new alternator 2003 kia sedona van. I replaced the alternator. The van starts but will not hold a charge. The system is obviously not charging the battery. Can

Rear brakes how to install them Removal 1.Remove rear wheel and tire assembly from vehicle. 2.Remove rear brake drums from hub and bearing assemblies after loosening the two brake drum screws. 3.Be ...

...a fully charged new battery fitted then the problem is the connection from the battery, check the earth strap is making a good contact on the chassis and the terminals are connected correctly and ...

...Try looking at your battery connections and make sure they are all clean and tight, also check your earth connections from the battery to the body & engine. Get your battery checked, other than ...

I'm not getting power to fuel pump on a 2003 kia Sedona fuse is good relay is good, will run if jumped out Check continuity of cable to pump. Do you get a voltage reading on supply to pump? If no the ...